0014 – Band saw sharpener with a teeth setter

0014The sharpening method is based on the removal of a thin metal layer from a worn part of a tooth with the simultaneous formation of a tooth profile. The shape of the tooth is determined by the design of the control cam. Installation is completed with two cams for different tooth shapes.

By adjusting the scenes of the cam, sharpening of saws with a straight rear edge, such as ‘Woodmizer ',‘ Lenox', etc is provided. By adjusting the scenes of the cam, sharpening of saws with a convex rear edge, such as: ‘Uddeholm ' is provided. The installation allows you to adjust the height of the tooth, the pitch and location of the cavity. Tooth setter are produced by the following formulas:
left-right-left-right, etc.
straight-left-right-straight, etc.
straight-right-left-straight, etc.
To control the amount of wiring there is an indicator. After sharpening and setting the saw, the installation automatically stops.
Saw sharpening time (4.25 m): 5 min
Width of the saw : 20 - 50 mm
Adjusting the front angle of the tooth: 0 - 20 degrees
Length of the saw: 4 - 5 m

©2019 “IRM” AS. All Rights Reserved.

Search